Specification:
Item Name: 260mm Frame Kit & F7 Flight Controller w/ 40A ESC Stack Combo
Eachine Tyro119 HD 260mm Frame Kit ( More Details) | Brand Name: Eachine Model: Tyro119 HD Wheelbase: 260mm Material: 3K Carbon Fiber Arm Plate Thickness: 5mm Upper Plate Thickness: 2mm Bottom Plate Thickness: 2mm Center Plate Thickness: 2mm Side Plate Thickness: 1.5mm Standoff Height: 35mm Camera Mount Width: 20mm Weight: 108g |
iFlight SucceX-D Mini F7 TwinG FC & 40A ESC Stack ( More Details) | Brand Name: iFlight SucceX-D Mini F7 Flight Controller MCU: 216MHz STM32F722 Gyroscope: 2x ICM20689 Blackbox: 32MB Betaflight OSD: YES BEC: 5V 2.5A / 9V 2.5A Current sensor scale: 100 Inverter for SBUS input (UART2-RX) Smartaudio & Tramp VTX protocol supported Beeper pad: Yes RSSI input pad: No UARTs:5 Motor outputs: 4 8 pin 4in1 ESC port (GND, VBAT, M1, M2, M3, M4, CUR, R5) 6 pin DJI Air Unit port (R1, GND, R2, T2, GND, 9V) BLHeli32 Telemetryï¼RX5 Input voltage: recommended 2-6S, MAX 6S Firmware: IFLIGHT_F722_TWING Mounting pattern: 20*20mm Ï3 Dimensions: 29*29mm USB type-C 40A BLheli_32 4in1 ESC MCU: STM32F051K66 Up tp 48kHz PWM frequency Capacity: 470uF/50V Current Sensor: Yes Input: recommended 2-6S Constant: 40A / Burst: 50A BlHeli32 telemetry: Yes Supports up to Dshot1200, Proshot, Oneshot, Multishot Target: iFlight-BL32-4IN1 Weight: 7.2g Mounting pattern: 20*20mm Ï3mm with Grommets Ï2mm Dimensions: 31*31mm (including the power pads) |
Package Included:
1x Eachine Tyro119 HD Frame Kit
1x 3D Printing TPU Part Combo ( for installing DJI Air Unit, DJI Air Unit Modue NOT Include)
1x 3D Printing TPU Antenna Mount
1x SucceX-D F7 Mini TwinG Flight Controller
1x SucceX Mini 40A 4in1 ESC
2x Capacitor
1x bag of Cables
1x bag of Screws
