â Compatible with all major FPV receivers from vendors such as Fatshark, ImmersionRC, etc.
â Support the standard 40CH set: band A, B, E, Fatshark, and Raceband.
â Telemetry input allows remote control by the flight controller ( where supported ). Change channel, transmit power, and more from Betaflight OSD, flight controller USB port, Taranis, and more.
â Variable transmit power from 25mW to 600mW. Use 25mW for a race and then easily switch to 600mW for freestyle.
â Pit Mode allows you to power up safely without the risk of knocking other pilots out of the air.
â Mono audio input allows you to install a microphone, so you can listen to your motors while you fly, no matter how far away you fly.
â Standard 36mm form factor allows you to mount the Atlatl directly in your flight controller stack.
MCU: STM32F405RGT6Â 32-bit processor
IMU: ICM20689 ( SPI )
USB VCP driver ( all UARTs usable simultaneously; USB does not take up a UART )
Support serial receivers ( SBUS, iBus, Spektrum, Crossfire ) only. PPM and PWM receivers are not supported
128 Mbit Dataflash chip for Blackbox logging
Mounting holes:Â standard 30.5mm square to center of holesÂ
| Brand: Holybro
Type: Flight Controller
Dimension and Weight
| Product weight: 0.0155 kg
Package weight: 0.0400 kg
Product size (L x W x H): 3.60 x 3.60 x 2.00 cm / 1.42 x 1.42 x 0.79 inches
Package size (L x W x H): 9.00 x 6.50 x 2.50 cm / 3.54 x 2.56 x 0.98 inches
|Package Contents: 1 x VTx Board, 1 x Heat Sink, 1 x 80mm SMA - MMCX Cable, 1 x 150mm 4 Pin JST GH Wire|