Sub250g FPV Drone Build - 06 - ExpressLRS Receiver

Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST:
SUPPORT ME ON PATREON at:
THIS IS MY FULL TIME JOB. Here are other ways that you can support me: /
---
I receive a commission (at no extra cost to you) if you make a purchase after clicking one of the affiliate links below.
Buy the Analog Sub250g build kit at:
* GetFPV -
* RaceDayQuads -
Buy the HD-Ready Sub250g build kit at:
* GetFPV -
* RaceDayQuads -
---
All videos in this series are in this playlist:
---
00:00:00 - This is part of a series
00:01:06 - What's a receiver? What's ExpressLRS?
ExpressLRS main website is: /
It has lots of support info and tutorials!
00:03:53 - DJI users could choose the RC controller
If you decide to use the DJI RC controller, here is your tutorial:
How to flash ExpressLRS:
00:05:25 - I'm using the Radiomaster RP1
00:06:57 - ELRS Receiver Wiring
00:08:39 - Solder wires to the receiver
00:11:52 - Plug the RX into the FC
00:13:44 - Heat shrink and install the RX
00:15:19 - Install the FC nuts
00:15:50 - Mount the RX
00:18:06 - Mount the RX antenna
A generic antenna mount that will work with most any receiver you're using:
00:20:06 - About ExpressLRS Binding
00:21:12 - About the RadioMaster Boxer
00:22:28 - Set up ELRS options
00:25:11 - Bind the ELRS RX to the controller
00:27:47 - Does your RX power up from USB?
00:28:40 - Binding alone is not enough.
00:30:12 - Configure the Betaflight Ports tab
00:31:24 - Configure Betaflight Receiver tab
00:32:37 - What if your colored bars disappear
00:34:44 - Enable Telemetry
00:35:20 - Recap