Specificaiton:
Brand Name: Airbot
Item Name: F7 Flight Controller AIO OSD BEC
MCU: STM32F722
Input Voltage: 3-6S Lipo
- Betaflight OSD
- BEC: 5V @ 2A
Size: 36x36mm
Mounting Hole: 30.5x30.5mm
Features:
• STM32 F722 MCU, Runs Betaflight firmware
• ICM Gyro Over SPI Bus
• 30.5*30.5 mm Mounting holes
• Supports Lipo direct plugin (3-6S)
• Supports 5V 2A BEC output (Buck)
• STM32 controls OSD chip over SPI in DMA mode (Betaflight OSD)
• More UARTs (6xUARTs)
• Supports camera control function
• Supports ext. Gyro box
• Onboard 128Mbit(16MB) flash for balckbox
Resources Setting:
Package Included:
1x Airbot F7 Flight Controller
Resources Setting:
| Function |
Solder Pad Silk Screen |
Resources | MCU Pin | Notes |
| SBUS | SB | RX 1 | PA10 | |
| DSM2 | TX1 | TX 1 | PA9 | CLI: serialrx_halfduplex set to ON |
| Smart Audio VTX | S/A | TX 5 | PC12 | |
| Smartport | S.P | TX 4 | PA0 | |
| ESC Telemetry | TLM | TX 2 | PA2 | CLI: set esc_sensor_halfduplex = ON |
| Camera Control | CC | PA8 | ||
| SDA | SDA | I2C1_SDA | PB9 | Ext. Pull up needed |
| SCL | SCL | I2C1_SCL | PB8 | |
| GPS | RX6/TX6 | UART 6 | PC6/7 | |
| WS2812B LED | LED | PA15 | ||
| Buzzer | Bz-/Bz+ | PB0 |
Package Included:
1x Airbot F7 Flight Controller
