5" Micro Drone...Wait, WHAT?? ???? Propellers TOO BIG for Quadcopter Frame

You can now support RCwithAdam (and gain special perks!) HERE: 🤗
Visit my website here: / 💻
Only have a minute? Skip to 11:05 for a super sweet B-roll flight sequence!
*Don't try this at home* Time for Adam to try another one of his ridiculous ideas!! Let's see if we can cram the electronics of a 5" sized FPV drone into a 3" size quadcopter frame... and still fly it!
3D Printed Propeller Hub Part II
COMMENT BELOW what you learned from this video!
👉UPDATE 4.22.20: HERE ARE LINKS to the TinkerCAD designs for the motor adapters, in case you're interested!
Tall adapter
Short adapter:
NOTE: This design is not perfect, and if I were to use them again I would make a few changes to give the holes extra wall thickness.
This is the filament I used for the 3D prints
*SAFETY NOTE: for the close-up shots of the quad flying, I made sure to where safety glasses to protect my eyes in case something unexpected was to happen. Be prepared!
#microdrone #makersgonnamake
Support RCwithAdam by purchasing through these links!
Amazon
Banggood
I have a website /
-------
RC with Adam GEAR
RADIO:
QUAD RECEIVER:
AIRPLANE RECEIVER:
QUAD PROPS (my fav)
RC with Adam FILMING GEAR
Main camera
Action Camera
Mic
Camera stand
--------
Mandatory Disclaimer:
I participate in the Amazon Affiliates program, which means that if you click on one of the above Amazon links and purchase a product on Amazon, I will receive a teeny tiny commission (at no additional cost to you). Also, various other links listed here may be affiliate links, to which this disclaimer also applies.
**REMEMBER, always use caution and your best judgement when building and flying RC aircraft, be a good neighbor, and HAVE FUN!**
-----------
About RC with Adam: Adam makes FUN and HELPFUL videos about Radio Controlled aircraft, tech, and DIY projects! #RCwithAdam