DabberX HD 3" FPV Drone Frame | Will It Rip Review!

I finally got the chance to build and review the DabberX 3 inch FPV drone frame, and I have to say this little guy is wicked!
* I made this video over a few months due to the parts shortage and general life getting in the way of my flight time, but in those few months I got a chance to really see what the DabberX could do with the correct configuration and DJI hardware. The only change I could think to make to my current build would be an AIO F7 if you don't mind built in ESC's and are aiming for a sub250g AUW.
0:37 - Pre-build Overview
2:55 - Post-build Overview
6:08 - Flight Test
If you are interested in this frame contact these folks!!
Ben Ayer (QuadMonkeys FPV)
Insta: /
FB:
YT:
Damian Bailey (DabberX FPV)
Insta: /
FB:
YT:
DabberX 3" Top Mount for Session
Gear:
*3" DabberX Frame
Caddx Vista w/ Nebula Nano
Transtec F7 FC
Transtec 25A Blheli_S ESC
True RC Singularity 5.8
Ethix Flat Rat 1507 2800kv Motors
Gemfan Flash 3052 Props
TBS Crossfire Rx w/ Immortal T
TBS Mambo Standard w/ CRSF Tx v1
DJI V2 Goggles w/ Iflight Crystal
Shot with the DJI Osmo Action
Check me out on Instagram!
/
Thank You For Watching, I hope you enjoyed!!