Specication:
Brand Name: Holybro
Model: KAKUTE F7 Mini
Item Name: F7 2-6S Flight Controller & Tekko32 F3 45A Mini BL_32 4in1 ESC Combo
KAKUTE F7 Mini Flight Controller
MCU: STM32F745VGH6 32-bit processor,216MHz, 320Kbytes RAM, 1Mbytes Flash
IMU: ICM20689 (SPI)
Barometer: BMP280
USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
5.5 hardware UARTS (UART1,2,3,4,6,7)
Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only.
PPM and PWM receivers are not supported.
PPM and PWM receivers are not supported.
Onbord 16Mbytes for Blackbox logging
5V Power Out: 1.0A max
3.3V Power Out: 0.2A max
Dimensions: 33x26x6mm
Mounting Holes: Standard 20mm square to center of holes
Weight: 4g
Tekko32 F3 45A Mini ESC
Tekko32 F3 45A Mini ESC
Item Name: 45A BLheli_32 3-6S 4 in 1 ESC
Con. Current: 45A
Peak Current: 50A
- F3 MCU, runs double faster than F051
- 32bit ESC with BLHELI32 firmware
- Supports 3-6S lipo input
-PWM input, TLM supported
- Voltage output (VBAT)
- NO BEC
- Supports oneshot / Multishot / Dshot PWM
- Supports damped light
- Ext. cap needed for 6s (470uf 35v for 6s usage.)
- Mounting holes M2, 20x20mm
- Size:30 x 36 mm
- Weight: 7.8g
Atlatl Mini FPV Video Transmitter ( Manual)
Output Power: 0.5 mW (pit mode), 25 mW, 100 mW
Antenna Connector: MMCX
Input Voltage: 4.5 to 5.5 volts (nominal 5v power)
Dimensions: 19x16x4.5mm
Weight: 1.6g (without antenna)
Packag Included:Atlatl Mini FPV Video Transmitter ( Manual)
Output Power: 0.5 mW (pit mode), 25 mW, 100 mW
Antenna Connector: MMCX
Input Voltage: 4.5 to 5.5 volts (nominal 5v power)
Dimensions: 19x16x4.5mm
Weight: 1.6g (without antenna)
1x F7 Flight Controller Board
1x Tekko32 F3 4in1 45A mini ESC
1x 40CH FPV Transmitter
1x Tekko32 F3 4in1 45A mini ESC
1x 40CH FPV Transmitter
1x M2 Rubber rings
1x JST SH 8pin 30mm cable
1x JST SH 8pin 150mm cable
1x Electrolytic capacito: 470uF 35V
1x 8pin to 8pin 1mm pitch 65mm cable
1x 8pin to 8pin 1mm pitch 25mm cable
